Quipped ); Creen Door - Jayco 2010 Jay Flight Owner's Manual

E D W
NTRANCE OOR
Make sure the entrance door is completely
closed and locked when traveling. Locking
the door helps prevent it from opening
unintentionally.
The entrance door is located on the curbside
of the RV. Always hold onto the entrance door
when opening or closing it as damage caused
because you failed
warrantable.
BE SAFE, LOOK BEFORE ENTERING OR
EXITING YOUR RV!
H -A-B (
IDE ED IF SO EQUIPPED
The hide-a-bed sofa functions much the same
as a regular residential hide-a-bed sofa. To
make the hide-a-bed sofa into a bed, remove
the seat cushions and pull the sofa back
towards you firmly and gently. Activate (or
deflate) the air mattress using the supplied
furniture manufacturer's
convert the hide-a-bed back into the upright
sofa position, reverse the process .
J-S S (I S
TEEL OFA F
The J-steel sofa functions much the same as
a residential futon. To make the J-steel sofa
in to a bed, lift up on the bottom seat cushion
and pull it towards you. The sofa back will
drop down to provide a sleeping surface.
For additional comfort and to reduce fabric
damage, you may want to place a cover or air
mattress (customer supplied) over the J-steel
sofa when it is in the sleeping position.
B D (I
OOTH INETTE F
The dinette is designed to seat up to four
adults. You can access the dinette bench
storage by removing all the cushions and
lifting the bottom seat supports. If the dinette
bottom seat support is screwed shut, it is to
protect factory-installed equipment (do not
S D
ITH CREEN OOR
to do so is not
)
instructions. To
E )
O QUIPPED
S E )
O QUIPPED
CAMPING & OPERATING
use that area for storage). To convert back to
a booth dinette, reverse the process.
The booth dinette can be converted into a
bed. To convert, remove all the cushions from
the booth dinette. Lift the tabletop, remove the
detachable table legs and place the tabletop
on the ledges provided between the booth
dinette benches. Lay the seat back cushions
against the back of the booth dinette bench.
Lay the dinette seat bottom cushions in
between the seat back cushions. The area
where the cushions meet should be slightly
raised. Push the raised cushion ends down
gently. The cushions are designed to fit
snugly. Reverse this process when converting
back to the booth dinette.
Extendable dinette (if so equipped)
Your RV may be equipped with side
extensions on the dinette benches that can be
used only when the slideout is extended.
1. Remove the snap
strap (located at the
back of the dinette
bench) that secures
the extensions in the
travel position.
2. Pull out the dinette
bench extension
until it hits the
factory-installed
stops.
3. Remove the seat, seat back cushion and
plywood seat extender from the revealed
storage compartment (put the cushions off
to the side).
4. Position the plywood seat extender across
the dinette bench extension brackets. The
plywood seat extender MUST be in place
to use the extendable dinette.
5. Place the seat and seat back cushions on
the extensions and repeat the process for
the other dinette bench extension.
To close the extendable dinette, reverse the
process. The extendable dinette must be
closed, the snap strap secured and the
tabletop put in the bed position BEFORE the
slideout room is retracted for transit.
SECTION 10
Fig. 10.2 Extendable
dinette
67