Lideout - Jayco 2010 Jay Flight Owner's Manual

SECTION 9
SLIDEOUT SYSTEMS
the side of the seal to avoid the possibility of
water penetration.
Retracting slideout room
Press the IN section of the slideout control
switch and hold it until the motor stops.
Operating the switch after the room is fully
retracted will damage the switch and motor.
Maintenance
Do not work on your system unless the 12-
volt DC (auxiliary
supplied) and 120-volt
systems (shore line power cord) have been
disconnected.
Your slideout system has been designed to
require very little maintenance. To ensure a
long life of your slideout system, read,
understand and follow
instructions. This system contains a pre-lubed
bearing that is lubricated when the room is
moved in and out. Do not spray oil or grease
on the rails while the room is extended.
T
ROUBLESHOOTING
If the slideout does not move when the
slideout switch is depressed, follow these
steps.
Check the auxiliary battery (customer
supplied) for a full charge and good wire
connections.
Check the 12-volt fuse or circuit breaker.
Check for loose connections at the
slideout motor.
If the slideout still will not operate, follow
these steps.
If the slideout is extended, refer to the
following section on overriding the specific
slideout system installed on your RV.
If the slideout is retracted, leave it in that
position.
Contact your dealer or Jayco Customer
Service for repair assistance.
If the slideout extends crooked or only one
side moves, follow these steps.
64
battery, customer
AC electrical
these simple
T S
HE

LIDEOUT

Follow steps on overriding the specific
slideout system installed on your RV.
You may need to push the side that is not
sliding to get it to retract all the way.
Contact your dealer or Jayco Customer
Service for repair assistance.
RBW Slideout override
Inside the RV, locate
the hex head screw
on the front of the
slide motor. Using a
ratchet and 3/4"
socket, turn the
screw counter-
clockwise to retract
the slideout. Install
the travel bars in the
proper locations as
indicated by the wall labels.
Dexter Chassis Group (DCG) Center Drive
Slide override (flush floor models)
Disconnect the slideout motor brake wires
from the power wires. Connect a 9 volt battery
harness to the
motor brake
wires Locate
the manual
advance crank
nut on the
backside of the
motor. Crank
the nut on the
slideout motor
Fig. 9.5 DCG manual advance
with a 5/8"
crank nut
socket. With
the 9 volt battery connected to the motor
brake crank the nut on the motor until the
room is sealed. Once the slide is in a closed
position remove the 9 volt battery and
harness.
M-Tec slideout override
In the event of a power failure or low battery,
the slide-out room may be operated manually
with a 5/8" ratchet wrench (not supplied). The
manual crank shaft is located on the motor-
transmission housing.
clockwise to move the room "in", counter-
clockwise to move the room "out".
Fig. 9.4 RBW slide hex
head
Turn the crank