Sirius Satellite Radio Xpress RCi User Manual page 127

Dash
Mount
Option 2
Option 1
Option 3
IMPORTANTl Allow the Dash Mount adhesive to cure (dry) for a minimum
of 2-4 hours before using the mount. The best adhesion occurs after 24
hours.
CAUTION: The adhesive used on the Dash Mount may be difficult to remove•
Do not install this mount on leather surfaces (contact your vehicle dealer if you
are
unsure about your dash surface), and make sure the air temperature is at
least 60 °F (15 °C) during installation. If it's not at least 60 °F, turn on the heater
in your vehicle to bring the temperature up to 60°F.
Locate a flat surface for the Dash Mount. (Options 1, 2, or 3.) Make
sure there is ample room for the dock and radio when installed.
Set the orientation of the mount before adhering it. Loosen the
knob and adjust the adhesive foot for the location you selected:
• Option 1 & Option 3
should be oriented
as I.
• Option 2 should be
oriented as II.
3 The dock mounting plate can be tilted in different directions.
Adjust as necessary for your particular vehicle. When the
orientation is correct, tighten the knob.
Knob Adhesive Foot Dock Mounting Plate;;;",..._......
\ /
~="'-
)
~e
0
~
2
4 Clean the surface with the alcohol preparation pad, and let it dry
thoroughly.
5 Peel off the adhesive liner. Position, press, and
hold the Dash Mount in place for 30 seconds.
1
•
•
Install the Dash or Vent Mount
You can use either the Dash Mount or the Vent Mount for your Xpress
RCi
,
depending upon your vehicle and the
location where you want to place your radio.
CAUTIONl Make sure your radio isn't in a place where it could interfere with driver visibility or safe deployment of th
airbags.
IMPORTANTl When you install the chosen mount, do not yet attach the PowerConnect Vehicle Dock to the mount.
The cables must be attached prior to connecting the dock to the mount.
Installinq the Dash Mount: