Video Recording Settings; Loop Recording Time; Resolution - aguri VISION DX10 User Manual

To view a recording and display the GPS track, click on the 'Open' button and browse your computer until you find the
SD card reader and the folders and data recorded on the Micro SD card. Double click on the folder you want to review
and the video/GPS track files recorded will appear in the top right hand corner box of the Aguri DX10 Viewbox as
indicated above. Highlight the video file you want to run and press the Play button.

Video recording settings.

If you would like to fine tune any of the settings on your DX10, follow the instructions below.
Enter the Video setting menu by pressing the Menu/Return button and then press the down button to scroll through
the video settings.
Please note you cannot enter the Video playback mode whilst the video is recording. To stop your DX10 from
recording double press the Video/Playback/OK button.

Resolution

Use the down button to select 'Resolution' by pressing the Video/Playback/OK button. Use the up or down buttons to
choose between 1080FHD 1920*1080, 1080P 1440*1080 or 720P 1280*720 30FPS. Press the Video/Playback/OK
button to make your selection and return to the menu. Press the Menu/Return button to exit.
User tip. The higher the resolution selected the more memory required to save and store lengths of video. If you want to
store more video on one SD card, try reducing the resolution.
Loop recording
You can adjust the length of each loop of video recorded.
To change the Loop time, enter the menu, highlight 'Loop recording' and select it by pressing the Video/Playback/OK
button. Use the up or down button to choose between Off, 1 minute, 2 minutes, 3 minutes, 5 minutes or 10 minute
loops. Press the Video/Playback/OK button to save your selection and return to the menu.
To exit the menu, press the Menu/Return button.
9.