System Settings - aguri VISION DX10 User Manual

Video/Playback/OK button to save your selection and return to the menu.
To exit the menu, press the Menu/Return button.
User tip. An 'Emergency' or 'Event' recording, is a length of film that is saved because whilst recording, the DX10 G-Sensor,
sensed either a collision or a sharp change in speed or direction potentially indicating that an incident or accident has taken
place. As a result this 'event' is saved and locked so that it will not be immediately overwritten.

System settings

Enter the Menu by pressing the Menu/Return button and then press the Menu/Return button again to switch from
Video settings to System settings. Press the down button to scroll through the System settings.
Please note you cannot enter the Menu whilst the video is recording.
Date/Time
It is important to set the date and time, so that any accidents or incidents recorded are saved with the appropriate
time and date information attached to them.
To set the date and time, enter the System settings menu, use the up and down buttons to highlight 'Date/Time' and
select it by pressing the Video/Playback/OK button. Use the up and down buttons to change each value and press
Video/Playback/OK button to save your selection and move on to the next value. Once you have completed all
sections, press the Menu/Return button to save and exit.
Auto power off
If you would like your DX10 to power off when not in use, you can set it to automatically power off after 1, or 3
minutes.
To make your selection, enter the menu and use the up and down buttons to highlight 'Auto power off'. Select it by
pressing the Video/Playback/OK button and use the up or down button to choose between Off, 1 minute or 3 minutes.
Press the Video/Playback/OK button to save your selection and return to the menu.
To exit the menu, press the Menu/Return button.
12.