Epson SC-P800 User Manual page 131

SC-P800 Series User's Guide
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
European model:
Low Voltage EN60950-1
Directive
EN62311
2006/95/EC
EMC directive EN55022 Class B
2004/108/EC
EN61000-3-2
EN61000-3-3
EN55024
R&TTE EN300 328
Directive
EN301 489-1
1999/5/EC
EN301 489-17
EN60950-1
EN50566
For European users:
We, Seiko Epson Corporation, hereby declare that this
equipment is in compliance with the essential
requirements and other relevant provisions of Directive
1999/5/EC.
Appendix
For use only in Ireland, UK, Austria, Germany,
Liechtenstein, Switzerland, France, Belgium,
Luxemburg, Netherlands, Italy, Portugal, Spain,
Denmark, Finland, Norway, Sweden, Iceland, Cyprus,
Greece, Slovenia, Bulgaria, Czech, Estonia, Hungary,
Latvia, Lithuania, Poland, Romania, Slovakia, Malta,
and Croatia.
Only indoor operation is permitted in France. If used
outside of own premises, general authorization is
required in Italy.
Epson cannot accept responsibility for any failure to
satisfy the protection requirements resulting a
non-recommended modification of the products.
Australia, New Zealand Model
EMC:AS/NZS CISPR 22, Class B
Radio:AS/NZS 4268
EMF:EN 62209-2
131