NETGEAR FUSE User Manual page 51

You can clear these settings from the Mobile Hotspot Manager's Software and Reset page.
Clear Account Details Only
If you want to use your device with another account, you need to clear your current account.
You can clear these settings from the Mobile Hotspot Manager's Software and Reset page.
Note: All connected devices will be disconnected and your device will reboot automatically. You will have
to activate your device with your new account before they can reconnect.
1. In the Mobile Hotspot Manager, click Settings > General > Software and Reset.
2. Below Clear Programming, click Reset.
3. Click Begin Reset.
Reset Device Settings Only
If you want to reset your device to its default behavior, but don't want to change your account or network
activation, you need to reset your device settings.
You can reset these settings from the Mobile Hotspot Manager's Software and Reset page.
Note: All connected devices will be disconnected and your device will reboot automatically. After the
reset finishes, they can reconnect.
1. In the Mobile Hotspot Manager, click Settings > General > Software and Reset.
2. Below Settings Reset, click Reset.
3. Click Begin Reset.
Reset to Factory Default Settings
In some cases you will need to reset your device's software to its factory default settings.
WARNING: If you reset the software to default settings, you must go through the device setup, as if
you've just purchased your device.
You'll need to reset the software to default settings if:
●
You've forgotten the administrator password.
●
You've changed the DHCP settings such that your device is inoperable. (For example, there's no
communication with your device.)
You can reset your device to factory settings from the Mobile Hotspot Manager's Software and Reset
page or Support page.
Note: All connected devices will be disconnected and your device will reboot automatically.
Mobile Hotspot Manager (Browser) Interface
DRAFT
46