Set Up Your Pap2 - Linksys PAP2 Configuration Manual

SET UP YOUR PAP2

1. Using a standard telephone cable (RJ-11), connect an analog phone to the Phone1 port on the PAP2.
2. Using a standard network cable (RJ-45), connect the LAN port on the PAP2 to your network
connection (e.g., LAN).
3. Power on the PAP2 by plugging its power supply into an AC outlet and then plugging the power
cable into the Power port on the PAP2.
The table below lists some useful IVR options for the PAP2.
ACTION
Enter IVR Menu
Check DHCP
Set DHCP
Check IP address
Set IP Address
Check Net Mask
Set Net Mask
Check Gateway
Set Gateway
Check MAC Address
Check Firmware
Version
Manual Reboot
Landose Configuration Guide for the Linksys PAP2
PAP2 MENU OPTIONS
CODE USER INPUT
****
100
To enable, enter 1.
101
To disable, enter 0.
110
Use the phone's keypad to
enter the IP address. Press
111
the star (*) key to enter the
"dots" in the IP address.
120
Use the phone's keypad to
enter the Net Mask address.
121
Press the star (*) key to enter
the "dots" in the IP address.
130
Use the phone's keypad to
enter the gateway address.
131
Press the star (*) key to enter
the "dots" in the IP address.
140
150
7326668
Page 1
Wait until you hear the announcement,
"Configuration menu. Please enter
N/A
option followed by the pound (#) key,
You will hear the system announce the
N/A DHCP status, either enabled or
Press the number corresponding with
the desired option, followed by the
N/A
After entering the IP address, press the
pound (#) key. Ensure that DHCP is
"Disabled." If it is "Enabled," the
system announces, "Invalid Option" if
N/A
After entering the Net Mask address,
press the pound (#) key. Ensure that
DHCP is "Disabled." If it is "Enabled,"
the system announces, "Invalid Option"
N/A
After entering the gateway address,
press the pound (#) key. Ensure that
DHCP is "Disabled." If it is "Enabled,"
the system announces, "Invalid Option"
The system announces the PAP2's MAC
N/A
The system announces the PAP2's
N/A
Once the system announces, "Option
successful," you may hang up the
N/A
phone. The PAP2 reboots automatically.
BEHAVIOR NOTES
or hang up to exit."
disabled.
pound (#) key.
you try to set this value.
if you try to set this value.
if you try to set this value.
address.
firmware version.