Starting And Stopping Recording; Playback And Searching Backward/Forward - Tascam DR-10X Owner's Manual

Starting and stopping
recording
You can use a single operation to start recording
with this unit even when it is off.
8 One touch recording
When the unit is off, slide and hold the
¤ ?o — 0REC switch toward 0REC for
about one second until the
TASCAM DR- 10
startup message appears and recording starts.
8 Ordinary recording
To start recording when the unit is on, slide the
¤ ?o — 0REC switch toward 0REC for
about one second.
8 Stopping recording
Slide the switch toward 0REC during recording
for about one second to stop recording.
The following information appears on the display
when stopped, when recording starts and during
recording.
−12dB
Stopped
When recording
starts
14
TASCAM DR-10X
Recording
1 Level meter
2 Remaining battery charge
3 Recorder operation status
4 File name
5 Elapsed recording time
NOTE
• The one-second delay is intended to prevent
accidental operation.
• Without pausing recording, a new file can be
created automatically during recording when
the file size reaches 2 GB. (Track incrementing)
• Set the mic input sensitivity with the
item on the Menu Screen so that that activity
of the level meters reaches the arrow (at −12
dB) in the illustration. (See "Menu structure" on
page 16.)
Playback and searching
backward/forward
The Home Screen shown below appears after the
unit starts up.
8 Starting and stopping playback
When the Home Screen is open and playback
is stopped, press the 7'9 [ENTER] button to
start playback. Press this button again to stop
playback.
8 Searching backward and forward
During playback, press and hold the . [j] or
/ [k] button to start searching backward or
MIC GAIN
forward. Continue pressing and holding the .
[j] or / [k] button to accelerate the search
speed.
Release the . [j] or / [k] button to
resume playback.