Tascam DR-10C Release Notes

Update information

We recommend that you always use the latest firmware
version available for the unit. For information about
the latest firmware, visit the TEAC Global Site (http://
teac-global.com/).

New functions

V1.10 additions

•
44.1kHz, 16-bit and poly recording file formats can
now also be selected in addition to the 48kHz, 24-bit
and mono formats available before. These can be set
using the new menu items shown below.
:
FS SAMPLE 44. 1lkHz
:
BIT LENGTH 16bit
:
FILE TYPE MONO
NOTE
You cannot set the
FILE TYPE
the
DUAL REC MODE
•
If the remaining battery charge is low, the remaining
open space on the microSD card is low or recording
cannot be started, for example, the unit can now
output a warning sound (beeping) from the
headphone jack. This can be set using the new menu
item shown below.
:
WARNING BEEP OFF
NOTE
For details, download the latest DR-10C or DR-10X
Owner's Manual from the TEAC Global Site (http://
teac-global.com/).

Maintenance items

V1.10 fix

•
Operation stability has been improved.

V1.02 fix

•
When the
SYSTEM INIT
initialize settings), the
MODEL SELECT
is no longer reset.
This change only applies to the DR-10C.
NOTE
For details, download the latest DR-10C Owner's
Manual from the TEAC Global Site (http://teac-global.
com/).
D01263920B
DR-10C/DR-10X
, (default)
48kHz
, (default)
24bit
(default),
POLY
item to and
POLY
item to at the same time.
ON
(default),
ON
menu item is executed (to
item setting
Release Notes

Confirming the firmware version

Before starting firmware update procedures, check the
firmware version of the DR-10C/DR-10X you are using.
1. Turn the main unit on.
2. Press the button to open the
MENU
3. Use the .[j] and /[k] buttons to select
the menu item and press the
VERSION INFO
7/9[ENTER] button to show the firmware version.
4. Check the firmware version shown here.
Updating is not necessary if the firmware version
shown here is the same or newer than that of the
firmware version you intend to use for the update.

Firmware update procedures

CAUTION
When updating the firmware, the unit should be
using batteries with sufficient remaining power
or operating on USB bus power supplied from a
computer.
If battery power is low, conducting the update will not
be possible.
1. Download the latest firmware from the TEAC Global
Site (http://teac-global.com/). If the downloaded file is
in ZIP format or another compressed file type, decom-
press it.
2. Use the included USB cable to connect the unit to a
computer.
The screen shown below will appear. Use the .[j]
and /[k] buttons to select the
on the display, and press the 7/9[ENTER] button to
confirm.
The computer should recognize the unit as an external
drive (external storage).
3. Copy the downloaded firmware ("dr10.102" for V1.02)
to the root directory of the DR-10.
4. After copying the file, use the proper procedures for
the computer to unmount this unit before discon-
necting the USB cable. If the unit is on, turn it off.
Screen.
MENU
item
STORAGE
1
TASCAM DR-10C/DR-10X