Magnavox 27MT3305/17 User Manual page 6

2
I f your cable signal uses a cable box or
decoder, follow the easy steps below to com-
plete the connection.
Cable Box (w/RF In/Outputs):
This connection will be mono.
1 Connect the Cable Company
supplied cable to the signal IN(put)
plug on the back of the Cable Box.
2 Using a separate round coaxial cable,
connect one end to the OUT(put)
(TO TV) plug on the back of the
Cable Box.
Connect the other end of the
3
round coaxial cable to the 75Ω
input on the back of the television.
Screw it down finger tight.
NOTE: If applicable, set the OUTPUT
CHANNEL SWITCH on the back of the
cable box to CH 3 or 4.Tune the TV to the
same channel and change channels at the
cable box. In some cases, the cable box will
automatically tune to either channel 3 or 4,
change channels until the picture appears.
Cable Box (w/Audio/Video Outputs):
This connection will supply Stereo sound.
4 Connect the Cable Company
supplied cable to the cable signal
IN(put) plug on the back of the
Cable Box.
5 Using a RCA type Video Cable, con-
nect one end of the cable to the
Video (or ANT, your cable box may be
labeled differently) Out jack on the
cable box and the other end to the
AV1 Video Input on the TV.
Connect one end of the Audio Left
6
and Right Cable to the left and
right Audio Out L & R jacks on
the cable box. Connect the other
end to the AV In Audio L & R Input
jacks on the TV.
NOTE: Use the AV button on the TV
remote control to tune to the AV channel
for the cable box signal. Once tuned, change
channels at the cable box, not the television.
C B
ABLE OX
Cable Box (w/RF In/Outputs):
Cable Signal IN from the
Coaxial Cable
Cable Box (w/Audio/Video Outputs):
Cable Signal IN
from the Cable
L (White) & R (Red)
C
ONNECTIONS
Cable Company
Jack Panel Back of Cable Box
Round 75Ω
Company
Audio Cables
Jack Panel Back of TV
Cable Box with A/V Outputs
Video Cable
(Yellow)
Jack Panel Back of TV