Cable Connection - ATEN VM6404H User Manual

Cable Connection

Installation of the VM6404H is simply a matter of connecting the appropriate
cables. Refer to the installation diagram on the following page (the numbers in
the diagram correspond to the steps below), and do the following:
1. Use a grounding wire to ground the unit by connecting one end of the wire
to the grounding terminal, and the other end of the wire to a suitable
grounded object.
Note: Do not omit this step. Proper grounding helps to prevent damage to
the unit from surges or static electricity.
2. Connect up to 4 HDMI video sources to the HDMI Input ports
3. Connect up to 4 HDMI display devices to the HDMI Output ports
4. Connect the IR Receiver into the IR port.
5. (Optional) If using the Browser Operation features (see Browser
Operation, page 33), plug a Cat 5e cable from the LAN into the
VM6404H's Ethernet port.
6. (Optional) If you are using the serial control function, use an appropriate
RS-232 serial cable to connect the computer or serial controller to the
VM6404H's female RS-232 Serial port.
7. Plug the power cord supplied with the package into the VM6404H's 3-
prong AC socket, and then into an AC power source.
8. Power on the VM6404H and all devices in the installation.
Chapter 2. Hardware Setup
11