Connecting And Charging; Using Your Toothbrush - Braun SMART SERIES Oral-B BLACK 7000 User Manual

g Charge level display
h Charging unit (basic charger and brush head
compartment with protective cover)
i SmartGuide
j SmartGuide holder
k Wall mount
l Adhesive ring
m Travel case (depending on model)
n Travel charger pouch (depending on model)

Connecting and charging

Your toothbrush has a waterproof handle, is
electrically safe and designed for use in the
bathroom.
• Plug the charger into an electrical outlet. For
voltage specifications refer to the bottom of the
charging unit.
• The flashing blue lights indicate that the tooth-
brush is charging (picture 1, page 5); once it is
fully charged, the lights turn off. A full charge can
take up to 24 hours and enables up to 10 days of
regular brushing (twice a day, 2 minutes).
Note: After deep discharge, the blue lights might
not flash immediately; it can take up to 10–15
minutes.
• If the rechargeable battery is low a blue light is
flashing on the charge level display (g) for some
seconds when turning your toothbrush on/off. If
the rechargeable battery is empty the motor will
stop and an orange light is flashing on the charge
level display; it will need a 40-minute charge
before you can use it for a 2-minute brushing.
• For everyday use, the handle can be stored on
the charging unit to maintain it at full power.
Overcharging is impossible.
• Battery maintenance: To maintain the maximum
capacity of the rechargeable battery, unplug the
charging unit and fully discharge the handle with
regular use at least every 6 months.
SmartGuide adjustments
The SmartGuide (i) comes with a demonstration
mode. Deactivate this mode by removing the
compartment cover in the back (picture A, page 4)
and push the «set» or «h/min» button.
A flashing «12:00» indicates that you can now adjust
the clock time.
Note: If the SmartGuide display is blank before first
use (no active demonstration mode/no batteries
inserted) the batteries will need to be replaced/
inserted before continuing. Batteries are supplied.
Clock Time
Press and hold the «set» button until «12h» is dis-
played. By briefly pressing the «h/min» button, you
can toggle between «12h» or «24h» daytime format.
Push «set» to confirm your choice. Then the hour
digit starts flashing. Press the «h/min» button until
the right hour appears and confirm with «set». Pro-
ceed same way to set both minute digits (picture B,
page 4).
SmartGuide Icons
Displayed Meaning
Icon
«Daily Clean» mode
«Deep Clean» mode
«Sensitive» mode
«Whitening» mode
«Gum Care» mode
«Tongue Cleaning» mode
Too much pressure is applied.
Reduce the brushing force.
«Quadrant circle»
Move to the next quadrant of your
mouth when the relevant segment
flashes.
You reached the dentist recom-
mended 2-minute brushing time
(3-minute brushing time within the
Deep Clean mode).
After use your brushing time will be
rewarded with stars.
SmartGuide batteries are low.
Change batteries of the SmartGuide.

Using your toothbrush

Brushing technique
Wet brush head and apply any kind of toothpaste.
To avoid splashing, guide the brush head to your
teeth before switching on the appliance (picture 2,
13