Moving Machine By Hand - Husqvarna P-ZT 48 Operator's Manual

Moving Machine By Hand

When pushing or pulling the mower, engage the bypass
linkages with the hydro release levers. The levers are located
on each side of the rear of the unit below the engine plate.
Raise the deck to the highest (transport) position.
Pull the bypass linkages up and out of the keyhole slots.
Release the lever with the head outside the bracket and held
into the bypass setting.
To reengage the hydro to drive, reverse the procedure.
WARNING! Use extreme caution when loading the
machine into a truck or trailer using ramps. There is the
possibility of serious injury or death if the machine falls off
the ramps.
OPERATION
WARNING! Bypass linkages are located close to
the muffler. To prevent burns, the engine should be shut off
and allowed to cool before the bypass linkage levels are
handled.
WARNING! Make no adjustments without:
• the engine stopped,
• the ignition key removed,
• the park brake activated
20