Table of Contents
Advertisement
Fuses
Fuses are located on the right hand side of the machine and
are accessed by tilting the seat forward. Fuses are flat pin
fuses type as used in automobiles. The 20 A is the primary
fuse. The 7.5 A is for the mower deck coupling. The 10 A is for
accessories.
Cutting Height Controls
The cutting height pedal lifts the deck to allow setting the
desired deck height. For transport, push the lift pedal fully
forward until the deck lift latches in the transport (highest)
position.
To set the deck cutting height, release deck height control by
pushing forward on the pedal. Rotate the cutting height pin
180
to remove it and slip the pin into the hole for the desired
O
cutting height. The cutting height can be set from 1"- 5½" (2.5
cm-14 cm).
IMPORTANT INFORMATION Always raise the deck to the
highest position for transport.
CONTROLS
Fuel Shut Off Valve
The fuel shut off valve is located at the right rear of the seat.
The valve has three positions: right tank, left tank and OFF.
Tracking
If the mower is not tracking straight, check the air pressure in
both rear tires. Recommended air pressure for the rear tires is
15 psi (1 bar).
1.
Tracking adjustments are made using the tracking bolt
and tracking knob. The tracking bolt and tracking knob
act as limiting devices for the motion control levers when
in the full-forward position.
2.
For preliminary tracking adjustment, move unit to an open,
unobstructed area such as an empty parking lot or open
field.
3.
Back the tracking bolt out until flush with nut.
4.
Loosen tracking knob out until flush with nut.
5.
Test operate unit by driving it at full throttle and the full
forward position on both motion control levers. Gradually
turn in the tracking bolt on the right hand side until the unit
noticeably starts drifting right.
6.
Drive forward at full throttle with both motion control levers
in the full forward position. Gradually turn in the tracking
knob (left side) until unit tracks straight.
14
Hide quick links:
Advertisement
Table of Contents
