Choke Control; Blade Switch; Ignition Switch; Service Meter - Husqvarna P-ZT 48 Operator's Manual

Choke Control

The choke control is used for cold starts to provide the engine
with a richer fuel mixture.
For cold starts the control should be pulled up.

Blade Switch

To engage the mower deck, pull the knob out; mower blades
are disengaged when the knob is pressed down.

Ignition Switch

The ignition switch is placed on the control panel and is
used to start and stop the engine. On models equipped
with headlights, turn the key clockwise to ACCESSORY for
headlight use.
CONTROLS

Service Meter

The service meter displays the total number of hours the
engine has run and indicates when the engine and mower
need servicing.
After every 50 hours of operation, an oil can icon will appear
and stay on for two hours, before an automatic reset occurs. To
manually reset the the meter, turn the key off and on five times
at one second intervals. To service the engine and mower, see
the Service Journal of this manual.
NOTE: The service meter operates (clocks hours) only when
the engine is running. Be sure to turn the key off when the unit
is not in use, to prevent meter hours from accumulating.

Seat Adjustment Lever

The seat can be adjusted lengthways. The lever is located
under the right side of the seat (as seen by the driver in the
seat). When making adjustments the lever is moved to the left.
IMPORTANT INFORMATION
while unit is in motion.
13
Seat should not be adjusted