Adjusting The Vox Sensitivity; Video/Audio Switching - Amplicomms Watch & Care V130 User Manual

O
PERATING THE
sounds in the room being monitored are so loud that the red Sound
Level LEDs are activated.

Adjusting the VOX sensitivity

(VOX: Voice Operated Transmission = Sound detection)
The VOX function (sound detection) causes the system to start transmitting
automatically from the transmitter to the receiver immediately a voice or
sound is detected.
Press the button seven times.
This icon appears in the display.
Use these buttons to set VOX to OFF or adjust the sensitivity to one
of 5 levels (5 = highest sensitivity). When one of the five levels has
been set, the VOX icon lights up in the display.
• If the receiver is placed on the charger the display will switch off
after approx. one minute of inactivity, but will switch back on if trig-
gered by the vox detector in the transmitter or by pressing any but-
ton on the receiver.
However if VOX is set to OFF, the display will remain on all the time.

Video/Audio switching

You can manually switch off the display to save battery power. The sound
from the baby's room are to be heard permanently and the display will
automatically switch on again if triggered by the vox detector.
Press this button briefly.
For switching the display on again press this button again briefly.
36
R
ECEIVER
Helpline UK 0844 800 6503
(See page 44 for costs and hours of operation)