Operating The Transmitter; Switching The Transmitter On/Off; Connecting And Aligning The Transmitter; Night Vision - Amplicomms Watch & Care V130 User Manual

O
PERATING THE

Operating the Transmitter

Check the transmitter and receiver are working properly each time befo-
re the equipment is put into operation.

Switching the transmitter on/off

Position the transmitter in a good position for the monitoring tasks required
and align the camera lens to the area to be monitored.
Slide the switch to ON. The Power LED lights up.
The transmitter is now ready to operate.
To switch the unit off, slide the switch to OFF.
In the case of a low battery voltage, the Power LED flashes slowly.
In this event replace the 4 x AAA batteries with fresh alkaline cells.

Connecting and aligning the transmitter

Attention: Position the transmitter with a minimum distance of 1 m to
other electronic devices, otherwise there is a risk of mutual disturbance.
Point the upper section of the transmitter towards the baby or object
you want to monitor. Check that the baby or object is suitably displayed
on the receiver.

Night vision

The transmitter is equipped with 6 infrared diodes. This enables the trans-
mission of pictures from areas which are not illuminated. The night vision
function is activated automatically when the light conditions make it neces-
sary.
When the night−time vision function is activated, the screen display on
the receiver turns to black and white.
32
T
RANSMITTER
Helpline UK 0844 800 6503
(See page 44 for costs and hours of operation)