Bosch GSG 300 Professional Original Operating Instructions page 8

OBJ_BUCH-75-002.book Page 8 Thursday, March 13, 2008 10:06 AM
8 | English
Technical Data
Foam rubber cutter
Article number
Rated power input
Output power
Stroke rate at no load n
0
Stroke speed under load
Cutting capacity, max.
Weight according to EP-
TA-Procedure 01/2003
Protection class
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltages and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your power tool. The trade names of individual tools may
vary.
Assembly
Before any work on the power tool itself,
pull the mains plug.
Mounting the Saw Blade Guide
(see figure A)
Remove the screws 5 from the housing. Attach
the saw blade guide 2 onto the housing in such a
manner that the mounting pins engage into the
corresponding holes and secure with the screws
5.
Inserting/Replacing Saw Blades
(see figure B)
When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching
the saw blade.
Loosen and remove the knurled screws 7 togeth-
er with the spring washers and the cover plate 6.
1 609 929 N76 | (13.3.08)
GSG 300
Professional
0 601 575 1..
W 350
W 185
spm 3200
Place the cover plate 6 onto the set screws on
spm 2100
the housing and secure them with the knurled
screws 7, ensuring that the spring washers have
mm 300
also been mounted.
kg 1.6
Mounting the Base Plate (see figure C)
/ II
Insert the saw blade guide 2 into the correspond-
ing notch on the base plate 4. Tighten the ten-
sioning screw 8.
Dust/Chip Extraction
Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one's health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in con-
nection with wood-treatment additives (chro-
mate, wood preservative). Materials contain-
ing asbestos may only be worked by
specialists.
– Use dust extraction whenever possible.
– Provide for good ventilation of the working
– It is recommended to wear a P2 filter-class
Observe the relevant regulations in your coun-
try for the materials to be worked.
Firstly, insert the saw blade pair 3 into the
bottom of the saw blade guide 2, paying at-
tention that the longitudinal grooves of the
saw blades engage into the guide pin of the
saw blade guide.
Secondly, locate the top of the saw blade
pair 3 onto the drive tappets, ensuring that
the saw blades are properly seated in the
saw blade guide.
place.
respirator.
Bosch Power Tools