Advertisement
Quick Links
Advertisement
Related Manuals for ProAudio SW18
Summary of Contents for ProAudio SW18
- Page 1 Manual SW18 Subwoofer...
-
Page 2: Table Of Contents
• Operating Modes [1] SW18........ - Page 3 flying rails and the tripod flange. Replace them if necessary. Make sure that during operation on spacer tubes, no persons will stand close to the loudspeakers. Use only accessory parts specified by ProAudio Technology or original accessory parts from ProAudio Technology. Loudspeakers always produce a magnetic field. Make sure...
-
Page 4: Operation On System Amplifiers
(CSA operation mode). The CSA mode will be explained in detail on the following pages of this manual. Combinations of SW18 and tops, which are supplied via a 4-pole speaker cable, must only be connected at the rear SpeakON sockets of the SW18 subwoofers! Never use the SpeakON sockets on the front side. -
Page 5: Operating Modes
One amplifier channel will be assigned. Pin pair 1 can be used for tops. Front Front DELTA 8.4-DSP / 14.4-DSP – 2 x 2-pc Sub Array [SW18 – 2 CH] All four SW18 subwoofers are wired using 4-pole speaker cables. Two subwoofers on either side are each driven by one dedicated amplifier channel. - Page 6 Front DELTA 8.4-DSP/ 14.4-DSP – 1 x 3-pc Cardioid Sub Array [SW18-CSA] All three SW18 subwoofers are wired using 4-pole speaker cables. The two front-firing subwoofers and the single back-firing subwoofer are each driven by one dedicated amplifier channel. Two amplifier channels will be assigned.
-
Page 7: Mixed Operation Sw18 And Sw28
SW28 subwoofer. Both subwoofers may be combined in any desired configurations and setup variants. Likewise cardioid sub arrays (CSA) are possible in a mix mode with SW18 / SW28. The minimum impedance is 2 ohms on the DELTA14.4-DSP system amplifier and 4 ohms on the DELTA8.4-DSP system amplifier. -
Page 8: Mixed Operation Sw18 And Sw28 Csa
Rear Front DELTA14.4-DSP SW18-CSA All five subwoofers are wired using 4-pole speaker cables. The four front-firing SW18 subwoofers and the single back-firing SW28 subwoofer are each driven by one dedicated amplifier channel. Two amplifier channels will be assigned. Front Rear With ground coupling DELTA14.4-DSP SW18-CSA... - Page 9 Without ground coupling DELTA14.4-DSP SW18-CSA All four subwoofers are wired using 4-pole speaker cables. The front-firing SW18 and SW28 subwoofers and the single back-firing SW28 subwoofer are each driven by one dedicated amplifier channel. Two amplifier channels will be assigned.
-
Page 10: Drawings / Dimensions
Drawings / Dimensions:... -
Page 11: Technical Specifications
The relevant regulations must be observed and adhered to. EU Conformity Declaration: This declaration is valid for the SW18 loudspeaker of the manufacturing company ProAudio Technology GmbH. Included herein are all production items of the same type, as long as they have not been modified subsequently in structural or... - Page 12 Manual SW18 Subwoofer – 2012-11 ENG ProAudio Technology GmbH Hermann-Schwer-Strasse 3 78048 Villingen-Schwenningen Germany Phone: +49 (0) 77 21 / 99 81 96 - 0 Fax: +49 (0) 77 21 / 99 81 96 - 9 info@proaudio-technology.de www.proaudio-technology.de...