Normal Operation - Shure IS 6132 User Manual

DCS 6000 Digital Conference System
Press Reset to reset the number of Errors etc.
counted. After start up, some errors can be seen,
but if the numbers of errors are constantly
increasing, the cabling or a unit is defective. The
fault could also be a LAN connector, which is not
properly inserted. Please note the "click" from the
lock, when inserting the connector.
Press OK to return to the Set-up menu.
If the communication during start up is failing in a
way, that the Interpreter Unit will not work, this
screen will be shown instead of normal welcoming
screen.
LCD backlight
This menu gives the user the possibility to control
the dimmed LCD backlight:
LCD backlight:
■ON
The user can toggle the backlight setting between
ON and OFF by pressing the relay-select buttons.
Press OK to return to the Set-up menu
Only dimmed LCD backlight can be controlled using
this menu – strong LCD backlight will be available if
external Power Supply is connected
AB switch with mic on
AB switch with mic on means that the user can
change the outgoing channel from A to B even when
the microphone is active.
AB switch with mic on:
■ON
The feature is toggled between ON and OFF with
relay-select.
This feature is typically used in two language
scenarios where an interpreter is responsible for
translating from language A to B and also the
reverse from language B to A.
Press OK to return to the Set-up menu.

Normal operation

As mentioned in previous chapter the following type
of screen is shown short time after the system is
powered up:
11 SWE FLOOR
1 ITA FLOOR
3 FR FLOOR
4 DAN
OK
Cancel
OK
Cancel
2
ENGLISH
11
FLOOR SWEDISH
This screen will be different on the various
Interpreter Units, depending on the individual
set-up of the Interpreter Unit.
Please note, if the welcoming screen is not
disappearing, the Booth number has not been
set-up. For setting up the interpreter set, please
see the section "Set up for each interpreters set".
Selection of incoming language
When interpreting, the interpreter will listen to
either the "Floor" language or will listen to one of
the interpreted languages. The Floor button will
select the Floor language and the buttons a, b, c
and d select the pre-selected languages shown
on the LCD-display to the headphone output.
Each of the buttons can be pre-selected to any of
the interpreter channels.
When one of the buttons a, b, c and d is pressed
a LED is lighted in the button pressed indicating,
that this pre-select is chosen.
The two first characters in the display show the
channel number (e.g. 12 or 5) and the following
three characters
language in short (see language list).
When the Floor button is pressed the Floor
channel is selected and the green Floor LED is lit.
Also the indication in one of the buttons a, b, c
and d is removed.
OBS If the functionality, that pressing the Floor
button again shall switch the listening back to the
previous selection of (a, b, c or d) is required, at
setting in the CU 61xx can be changed. Please
consult the DIS factory for this option.
When one of the a-d channels is selected the
Floor LED goes out and the audio from the
selected channel is switched on instead of Floor.
It is then possible to change the listening channel
with the Relay select up and down push
buttons. When the highest number is reached
when stepping up, the counting restarts from 1.
The reverse will happen when stepping down.
If one of the buttons is held down for more than
one second the channels will scroll through the
languages with a speed of 2-4 languages per
second.
Only the number of channels set at the Channel
Set-up menu at the CU 61xx can be selected and
shown. The numbers will always be in succession
from 1 and up. The same is the case for the CS
6032 channel selectors, with the exception, that
the CS 6032 is also showing channel 0 (floor)
10
User Manual
show the corresponding