Aligning The Appliance - Bosch KAN series Installation Instructions And Instructions For Use

Aligning the appliance

To ensure that the appliance functions
correctly, it must be set level with a
spirit level.
If the appliance is not level, water may
flow out of the ice maker, ice cubes
may be irregular or the doors may not
close properly.
S Place the appliance in the designated
location.
S Attach the enclosed base panel with
3 screws.
S To prevent the appliance from rolling
away, screw down the front feet until
they are positioned firmly on the floor.
S Rotate the feet until the appliance is
aligned exactly. Use the doors as a
reference point!
Freezer compartment door is deeper:
Refrigerator compartment door is
deeper:
If the previous steps for aligning
the door are not adequate:
S Remove the base panel.
S Loosen 3 hinge screws. Do not
completely unscrew the screws!
S Place the wrench on the adjusting
screw.
- To raise a door:
Rotate the wrench clockwise.
- To lower a door:
Rotate the wrench
anti clockwise.
Note:
Due to the weight of the appliance and
the food load in the door, the refrige
rator compartment door may incline,
even if the appliance itself is level.
The door gap is not the same at the top
and bottom.
S Remove the upper hinge cover (1).
S Loosen hinge screws (2). Do not
completely unscrew the screw!
S Adjust the inclination of the
refrigerator compartment door.
S Tighten the hinge screws.
S Fix the hinge covers.
en
21