Speciality Features - Magnadyne M9900CDS Installation And Operation Manual

Speciality Features

Display Button: The factory default setting is clock display priority. Push the
DISPLAY button at any time will display the radio frequency, CD track,
AUX 1 or AUX 2.
Note: In the Sirius mode the factory default setting is Sirius channel dis-
play priority. Push the DISPLAY button at any time to display the
CN-NAME, SONG TITLE, ARTIST, CATEGORY and Clock. If clock is cho-
sen the time will be displayed for approximately 5 seconds then revert to
displaying the Category.
Reset Button: The radio panel or LCD display may fail to function normally
due to the vehicle's battery condition, and may require resetting the radio
microprocessor if:
• The vehicle has been "jump started" from a dead battery condition.
• The vehicle battery becomes very low and is quick-charged.
• The vehicle battery is removed and replaced.
Should this condition occur, simply press and release the RESET button
on the radio panel using the tip of a ball point pen. This will reset the
radio microprocessor to the original factory settings. After pressing the
RESET button you should recheck to see if the radio functions normally.
All station programming should remain, but you will have to reset the
clock. Should the LCD display area show any abnormal error code, please
refer to the trouble shooting guide and solution chart below.
Error Code Problem
ERR 1 Mechanism Problem Unknown mechanical
ERR 2 TOC Reading Error
ERR 3 Error from High
Ambient Temp.
ERR 4 Laser Focus Error
ERR 6 CD Loading Error
ERR 7 Laser Servo Error
Description
problem with the CD
mechanism.
Laser can not read the
CD disc table of
contents.
The temperature of the
mechanism is too high
to play CDs without
damaging them.
Laser pickup fails to
focus and read the disc. 2. Check disc for excessive scratches.
The loading mechanism 1. Push the reset button.
is damaged.
Laser servo is not
functional.
Possible Remedy
1. Eject the disc and try another.
2. Press the reset button.
3. Replace the unit.
1. Insert a different disc.
2. Check disc for excessive scratches.
3. Check disc for dirt and fingerprints.
Clean disc and reinsert.
Reduce the temperature inside the vehicle
and try to play a CD at a later time.
1. Insert a different disc.
3. Check disc for dirt and fingerprints.
Clean disc and reinsert.
4. Press the reset button.
2. Replace the unit.
1. Press the reset button.
2. Replace the unit.
EQ DISP
LOUD MUTE
EQ DIS
ENTER
INTRO
BAND W-B
11