Introduction Your new M3300CD in-dash entertainment system has been designed to give you many years of listening pleasure. Take a moment to read through this manual and become familiar with the operations and features of this outstanding product. It is advisable to keep this manual in your vehicle so it is readily available for reference. Be sure to fill out and send in your warranty card to ensure that you receive the full benefits of warranty repair in the unlikely event that your system will need service.
Page 3
Location and Function of Controls at a Glance (continued) 6. Mode Button (MODE): Press the MODE button to change the operating mode as follows: RADIO > CD* > USB* > SD* > AUX > RADIO. *Available only when there is media inserted into Disc slot, SD card slot or USB slot. l ) : Adjusts the radio frequency, changes tracks and sets the clock .
Radio Operation Select a Band Press the MODE button until either F1, F2, F3, A1 or A2 appear in the display. Next press the BAND button to select the desired band: F1, F2, F3, A1 or A2. Tuning Automatic Search Tuning: Press the button to move to the next or previous sta- ��...
VOL knob clockwise to increase the balance to the front speakers and counterclockwise to increase the balance to the rear speakers. Equalizer The M3300CD has pre-programmed audio set- tings. To switch the equalizer settings push and hold the VOL knob for a few seconds then release.
(not supplied with this unit). Press the MODE button until “AUX” appears in the display to access the auxiliary device’s audio. Note: The M3300CD will not control the auxiliary audio source. Fast Forward and Fast Reverse Press the...
Page 7
CD, USB and SD Card Operation (continued) File / Folder Search Function When playing MP3/WMA files from a CD, USB Memory or SD/MMC Card, press AS/PS button to enter search mode. Sequence of search modes: File Number Search -> File Name Search -> Folder Search ->...
Installation Procedures Step 1: The radio chassis is designed to be “Sleeve Mounted” through a opening in the dashboard panel. The required opening size is 182mm (7-3/16”) x 52mm (2-1/16”). Cut or enlarged an opening in the dashboard to accommodate the mounting sleeve. Step 2: If you are replacing an existing factory installed radio, an adapter harness might be avail-...
Wiring Diagram Red Wire Ignition Switch (+12v in ) Yellow Wire Battery (+12v in) Black Wire Ground (B-) Blue Wire Power Antenna (Switched 12v out) Left White Wire Front Speaker White Wire with Black Stripe Left Green Wire Rear Speaker Green Wire with Black Stripe Antenna 15 A...
Audio Line Out Connection M3300CD Sub Woofer Connection M3300CD Blue (Sub Woofer) Final Installation - Method A Push Out Mounting Sleeve Tabs Installing the Unit 1: Insert the sleeve into the dashboard opening and bend the mounting tabs outward to secure it.
Final Installation - Method B Installing the Unit 1: Screw holes on the side of the unit. 2: Screws. Use wither truss screws (5 x 8mm) or flush surface screws (4 x 8mm), depending on the shape of the screw holes in the bracket. 3: Vehicle’s factory mounting bracket.