Verify Anti-Tip Bracket Location; Level Range; Install Griddle - Jenn-Air JGRP430W Installation Instructions Manual

30" (76.2 cm), 36" (91.4 cm) and 48" (121.9 cm) pro-style® gas convection ranges
Hide thumbs Also See for JGRP430W:
Table of Contents

Advertisement

Available languages

Available languages

Complete Connection
1. Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
A
A. Closed valve
B. Open valve
2. Test all connections by brushing on an approved
noncorrosive leak-detection solution. If bubbles appear, a
leak is indicated. Correct any leak found.
3. Remove cooktop burner caps, burner bases and grates from
parts package. Place burner bases on cooktop, burner caps
on burner bases and place grates over burners and caps.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
4. Plug into a grounded 3 prong outlet.
5. Turn on power supply. For further information, please refer to
the user instructions located in the Use and Care Guide.

Verify Anti-Tip Bracket Location

1. Turn all 4 leveling rods 1 full turn to raise the range and
provide enough clearance for the rear leveling leg to slide into
the anti-tip bracket.
2. Move range into its final location making sure rear leveling leg
slides into anti-tip bracket.
3. Use a flashlight to look underneath the bottom of the range
and visually check that the rear range foot is inserted into the
slot of the anti-tip bracket.
10
NOTE: Range must be level for satisfactory baking performance.
1. Place rack in oven.
2. Place level on rack and check levelness of the range, first
B
3. If range is not level, adjust the leveling rods. Turn leveling
NOTE: All roller feet must be off the floor upon final installation.
The griddle is factory installed.
1. Place drip tray in the well at the front of the griddle. Slide tray
2. Clean griddle before using. Refer to the Use and Care Guide.

Level Range

side to side; then front to back.
rods located behind the kick plate to level range and to raise
or lower range to the desired countertop height.
A
B
A. Front leveling rod
B. Rear leveling rod

Install Griddle

(on griddle models)
toward the back until it stops.
A
A. Griddle drip tray
B. Griddle
A
B
B

Advertisement

Table of Contents
loading

Table of Contents