Programmer/Receiver Settings; User; Heating - Worcester Greenstar Comfort I RF Installation And Operating Instructions Manual

5

Programmer/Receiver settings

There are two levels of settings:

1. User

2. Installer
5.1 User
Press the menu button for more than three seconds to enter the
User setting area of the Programmer/Receiver.
Five icons are shown across the top of the display:

1. Heating

2. Hot water
3. Holiday
4. Info
5. Settings
3
1 2
pmam
Fig. 13 User menu
Turn the knob to select an icon, the icon is encircled to confirm
the selection, and press the knob to enter that section.
If any of the menu names are accompanied by flashing arrow
heads at each end of the name, this indicates that there are
other menus available by turning the knob.
The display will dim after 20 seconds of
inactivity and remain dimmed until a button
is pressed or the knob is turned/pressed.
After 60 seconds of inactivity the display will
return to normal operation.
5.1.1 Heating
This Time program is used to set your required ON and OFF
times for the central heating. The Programmer has default time
settings as shown below:
06:30 08:30
CH ON OFF
Comfort I– 6720810964 (2014/07)
4 5
16:30 22:30
ON OFF
Time program
Select Time program with the knob, and press to enter.
Press the Return button
previous higher level.
In the Time program you can select ON and OFF times for the
central heating, there are three ON and three OFF programs.
Using the knob you can select various combinations of days, for
example:
1. Mon to Fri
2. Sat and Sun
3. Monday, Tuesday, Wednesday, Thursday, Friday, Saturday
and Sunday
Whether you choose to set the same times for Monday to Friday
and different times for Saturday and Sunday or set times for
individual days the setting operation is the same.
▶ Select the desired day(s) using the knob
▶ Press the knob to select the first Heating ON setting
▶ The hours flash
▶ Turn the knob to select the desired hours setting
▶ Press the knob to confirm
▶ The minutes flash
▶ Turn the knob to select the desired minutes
▶ Press the knob to confirm
▶ The first Heating OFF hours flash
▶ Turn the knob to select the desired hours setting
▶ Press the knob to confirm
▶ The minutes flash
▶ Turn the knob to select the desired minutes
▶ Press the knob to confirm
▶ Now the second Heating ON hours flash
▶ Repeat the process to set the hours and minutes for the
seconding Heating ON times
▶ Repeat the process for the second Heating OFF times
If the third heating period is not required
repeatedly press the knob to cycle through the
third period without making any settings.
▶ Repeat the whole process for the third Heating ON and OFF
times, if required
If after setting the third time period you decide that you no
longer require it and wish to disable it, follow these steps:
▶ In the Time program, cycle through time periods 1 and 2 by
just pressing the knob to accept the time setting until you
reach period 3
▶ Turn the knob to set the flashing hours to 00
▶ Press to accept and the minutes flash
▶ Turn the knob clockwise to 00 and then the display
changes to just bars and period 3 is disabled
Programmer/Receiver settings
at any time to return to the
11