Uniden DECT 2145 Series Owner's Manual page 6

For wall mount use only
1. On the front of the base, pull
the clip (that holds the corded
handset in place) out of its slot.
2. Rotate the clip 180 degrees.
3. Flip it from front to back and
slide it back into the slot.
Connect the power and telephone Cords
1. Connect the base AC adaptor to the DC IN 9.0V jack and the telephone
cord to the TEL LINE jack. Route the cords as shown below.
2. Plug the AC adaptor into a standard 240V AC power outlet, and connect
the telephone cord to a standard telephone wall jack.
3. If you are mounting the phone on the wall, place the mounting slots over
the pins on the wall plate; slide the base down to lock it into place.
For desktop Use
DESK
DESK
WALL
6
For Wall Mount Use
DESK
WALL
WALL