Advertisement
Quick Links
Advertisement
Related Manuals for Advent CHVNAV2
Summary of Contents for Advent CHVNAV2
- Page 1 CHVNAV2 Select Chevrolet Vehicles...
- Page 3 Components： HDMI Cable Video Output Flash GPS Antenna Cable Chevrolet T-Harnesses VHB Tape Video Input Cable Interface Module Suggested Installation Tools: Towel Screw Driver Components Pry Tools...
- Page 4 1: Using a nylon pry tool, carefully remove the trim bezzel covering the radio screen components. 2: Remove the 4 screws shown and remove the controls and screen assembly.
- Page 5 3: Remove the dash cover panel to access the factory speakers. If the vehicle does not have a center chanel speaker you will use the front left dash speaker for Nav Audio. If equipped with a center speaker after dash panel removal, remove the center speaker cover to access that speaker.
- Page 6 4: Disconnect the wireing from the Radio Module and remove from the dash by pressing down on the release hook and pulling toward you. 5: Route the speaker wire connection on the Nav interface harness up to the area below the dash cover. If there is a center speaker unplug the speaker connection and connect the speaker to the harness, then connect the speaker harness to the nav harness,...
- Page 7 6: Put the radio control module back into it's location. 7: Connect the Nav interface harness to the power connection of the radio and the radio power wire to the Nav Harness.
- Page 8 8: On the HMI module below, connect the Nav T- harness to the power connection as shown. 9: Disconnect the BLUE video connector on the HMI module and connect to the provided extension cable that will run to the Nav interface. Connect the provided Video cable from the HMI Blue port to the other port on the Nav interface, this completes Video in and out.
- Page 9 10: The Nav interface module will be located above the glove box or any other area that you have access to and can securely mount the module. 11: Route the wire harness white color connectors to the Nav Module final location. 12: Connect the white color connectors to the Nav module.
- Page 10 14: Connect and install the USB and HDMI cable connections in a location the customer can access to use these features. The USB connection is used for Map and System Updates, there is no reason for the customer to access the Nav module once it is installed. The USB will also charge a connected device but is not for media use.
-
Page 11: Wiring Diagram
Wiring diagram Antenna Install antenna in car GPS antenna installation Clean adhesion area with oil-soluble detergent, and fix GPS antenna with adhesive tape tight. . Remove the right cover of storage box, thread the cable from storage box to center console and tie up with OEM cable together. - Page 12 Wiring diagram: NOT USED HDMI Rear View Camera NOT USED Interface Module Audio USB Connector Power Connector Connector 5Amp Fuse To Vehicle Central Left Front GPS Antenna Speaker To HMI To Radio Black Gray 16 Pins 20 Pins Connector Connector To HMI Blue LVDS Connector...