Table of Contents
Advertisement
Network Deployment
General Connection (with PoE)
4. If you have external devices such as sensors and alarms, connect them to the general I/O
terminal block. Install the camera base to the mounting hole at the bottom of the camera.
5. Connect the camera to a switch using an Ethernet cable.
1. DO+
2. DO-
3. DI1+
4. DI2+
5. DI3+
6. DI- (common GND)
7. RS485-
8: RS485+
9. AC/DC pw
10. AC/DC pw
NOTE:
•
The camera is only to be connected to PoE networks without routing to outside plants.
•
For PoE connections, use only UL listed I.T.E. with PoE output.
6. Use the included hex wrench to access the SD card socket. Install an SD card.
TM
VIVOTEK
PoE Switch
User's Manual - 11
Advertisement
Table of Contents
