Vivotek IP816A-HP User Manual page 105

Custom Command
If Custom Camera (scanner) is selected as the PTZ driver, you will need to configure command
buttons to control the PTZ scanner. Click Custom Command to open the Custom Command
page to set the commands in the Control Settings session. Please refer to your PTZ scanner's
documentation to enter the commands in the following fields. Click Save to enable the settings and
click Close to exit the page.
►The command buttons will be displayed on the main page:
NOTE:
►If you select DynaDome/SmartDOME,
Lilin PIH-7x00, Pelco D, or Pelco
P protocol as the PTZ driver, the
Control Settings column will not be
displayed.
►For all PTZ drivers, a total of five
additional command buttons can be
configured.
VIVOTEK
User's Manual - 105