Electrical Requirements - KitchenAid KURL104EPA Use & Care Manual

Overlay Panel—Rear View
1. Create a custom overlay panel using the dimensions shown.
1"
(2.5 cm)
3¹⁄₈"
(7.9 cm)
2¹⁄₁₆"
(5.3 cm)
¹⁄₈" (2.8 mm) holes
Depth ⁷⁄₁₆" (12 mm)
2¹⁄₁₆"
(5.3 cm)
2¹³⁄₁₆"
(7.2 cm)
1" (2.5 cm) 2¹⁄₄" (5.75 cm)
Door Hinge Holes
■
The views of the top and bottom hinge pin hole show a right-
hand hinge. Mirror the image for a left-hand hinge.
■ We recommend using a C-clamp and two pieces of scrap
wood (front and back) to help reinforce the overlay panel
when drilling the hinge pin holes.
1. Using a ³⁄₈" brad point doweling drill bit, drill a hole, ⁹⁄₃₂"
(7.1 mm) deep, into the top of the overlay panel for the top
hinge pin. Remove the excess wood surrounding the hole by
using the rotary tool to complete the hinge depression as
shown.
Top View
A
¹⁄₂" (12.7 mm)
Depth
¹⁄₄"
(6.35 mm)
A. Diameter
2¹⁄₄"
(5.75 cm)
23³⁄₄"
(60.3 cm)
Top
29¹³⁄₁₆"
(75.8 cm)
¹⁄₂" (12.7 mm)
Front Surface
Back Surface
³⁄₈" (9.5 mm)
³⁄₈
" (9.5 mm)
2. Using a ³⁄₈" Brad point doweling drill bit, drill a hole,
³⁄₈" (10 mm) deep, in the bottom of the overlay panel for the
bottom hinge pin. Remove the excess wood, surrounding the
hole, by using the rotary tool to complete the hinge
depression as shown.
Bottom View
Depth
³⁄₈" ( 9.5 mm)
¹⁄₂" (12.7 mm)
A
A. Diameter
Front Surface

Electrical Requirements

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical
connection.
Front
¹⁄₄"
(6.35 mm)
³⁄₈" (9.5 mm)
³⁄₈"
( 9.5 mm)
Back Surface
Front Surface
¹⁄₂" (12.7 mm)
³⁄₈
" (9.5 mm)
³⁄₈" (9.5 mm)
³⁄₈" (9.5 mm)
5