TP-Link TD-W8901N User Manual page 37

IP Common Option: Configure the IP common option here.

Encapsulation: Select the encapsulation mode for the Dynamic IP Address, you can leave it

default.
Bridge Interface: Activate the option, the modem router can also work in Bridge mode.

Default Route: If enable this function, the current PVC will be considered as the default

gateway to Internet from this device.
TCP MTU Option: Enter the TCP MTU as your desire. The default value is 1500.

DHCP IPv6: There are two types of assignation for IPv6 address: DHCP (Dynamic Host

Configuration Protocol) Server and SLAAC (Stateless address auto-configuration). Select
your assignation type accordingly.
DHCP PD: The DHCP PD (Prefix Delegation) function is enabled by default. If you want to

disable the function, please click Disable.
MLD Proxy: The MLD (Multicast Listener Discovery Protocol) Proxy function is enabled by

default. If you want to disable the function, please click Disable.
2) Static IP Address
Select this option if your ISP provides static IP information for you. You should set static IP
address, IP Default Gateway and DNS Server address in the screen below (shown in
TD-W8901N 150Mbps Wireless N ADSL2+ Modem Router User Guide
Figure 4-11
29
F igure 4-12 ) .
X X X X