Advertisement
Instructions
1
Unpack Your Control Panel, Desk Mount and Transformer
1) Mount control panel to desk mount using the pre-aligned notches on the back.
2) Place mounted control panel in a convenient location for you and your family.
3) Plug transformer into wall socket and the system will start up.
2
Door/Window Contacts
1) Select transmitter and magnet locations as suggested below:
2) See photo on the right for proper magnet and transmitter alignment.
3) Peel and stick tape is included. Use alcohol swab to prepare surface.
When clean and dry, apply contact with even pressure for 15-20 seconds.
3
Motion Sensor
1) Peel and stick tape is included. Use an alcohol swab to prepare the surface.
When clean and dry, apply contact with even pressure for 15-20 seconds.
2) Determine a location at least eight inches down from the ceiling, no closer
than seven feet from the fl oor, and mount with the lens facing down.
3) Motion sensor has a 40° view and can detect up to 35 feet away.
4) Do not mount directly near or over a heat source, A/C unit, ceiling fan, or
facing a large window. See below for suggested mounting locations:
4
Install Additional Purchased Devices
• See insert for smoke and/or carbon monoxide detectors' suggested
locations from the National Fire Protection Association.
• Additional purchased devices or accessories will have instructions included
for mounting and/or setup.
5
Set Up User Codes and WiFi on your Lynx 5200 Panel
See page 4 for USER CODES and page 6 for WIFI
6
Set Up Total Connect on your Computer, Smartphone and/or Tablet
See page 8 (Total Connect activates separately. An email with your login
information will be sent within 24-48 hours.)
7
Call COMTRONICS to test your system
Select Option #3 to activate your system.
800-DIY-4757
3
Magnet
Spacer
Transmitter
Locate the two raised indicators on the
side of the transmitter and make sure the
magnet and transmitter are within 1/4" of
each other. The magnet height may need
to be raised to align with the transmitter
depending on your door/window frame.
Use the included spacer under the
magnet and/or screws, if needed.
The Motion Sensor can be mounted in a
corner or fl at wall mount location. Make
sure the sensor is mounted as shown in the
photo above, with the lens facing down.
For Help:
800-DIY-4757
(800-349-4757)
www.comtronicsDIY.com
Advertisement
