Table of Contents
Advertisement
MAINTENANCE
Your Black & Decker power tool has been designed to
operate over a long period of time with a minimum of
maintenance.Continuous satisfactory operation depends
upon proper tool care and regular cleaning.Your tool is not
user-serviceable. Take the tool to an authorized Black &
Decker repair agent. This tool should be serviced at
regular intervals or when showing a noticeable change in
performance.
Lubrication
Black & Decker power tools are properly lubricated at the
factory and are ready for use. Tools should be
re-lubricated regularly , depending on usage. This
lubrication should only be attempted by trained power tool
repair persons, such as those at Black & Decker service
centers or by other qualified service personnel.
Closed-type, grease-sealed ball bearings are used
throughout. These bearings have sufficient lubrication-
packed in them at the factory to last the life of the chop
saw.
Cleaning
Warning: unplug the tool before you use a cloth to
clean the housing.With the motor running, blow dirt and
dust out of all air vents with dry air at least once a week.
Wear safety glasses when performing this. Exterior plastic
parts may be cleaned with a damp cloth and mild
detergent. Although these parts are highly solvent
resistant, NEVER use solvents.
Blowing dust and grit out of the main housing by means of
an air hose is recommended and may be done as often as
dirt is seen collecting in and around the air vents. Always
wear proper eye and respiratory protection.
Tool Care
Avoid overloading the machine.Overloading will result in a
considerable reduction in speed and efficiency and the unit
will become hot. In this event,run the machine at no load
for a minute or two until cooled to normal working
temperature by the built in fan. Switching your machine on
and off whilst under load will considerably reduce the life of
the switch.
Important
To ensure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment (other than those listed in this
manual) should be performed by authorized service centers
or other qualified organizations, always-using identical
replacement parts. Unit contains no user serviceable parts
inside.Blowing dust and grit out of the main housing by
means of an air hose is recommended and may be done as
often as dirt is seen collecting in and around the air vents.
Always wear proper eye and respiratory protection.
NOTE: Unit may be converted to a 3-wire twist lock cord set
at an authorized service center.
ACCESSORIES
The performance of any power tool is dependent upon the
accessory used. Black & Decker accessories areengineered
to high quality standards and are designed to enhance the
performance of power tool.
Note: Accessory must be rated for use at speed equal to or
higher than nameplate RPM of tool with which it is being
used.
CAUTION: The use of any other accessory not
recommended for use with this tool could be hazardous.Use
only high-strength Type 1 organic bonded wheels rated
4100 rpm or higher. Recommended accessories for use with
your tool are available at extra cost from your local dealer or
authorized service center.
Protecting The Environment
Should you find one day that your tool needs
replacement, or if it is of no further use to you, think of
theprotection of the environment. Black & Decker
recommends you to contact your local council for
disposal information.
Service Information
Black & Decker offers a full network of company-owned and
authorized service locations throughout Asia. All Black &
Decker Service Centers are staffed with trained personnel to
provide customers with efficient and reliable power tool
service.Whether you need technical advice, repair, or
genuine factory replacement parts, contact the Black &
Decker location nearest to you.
Notes
Black & Decker's policy is one of continuous
•
improvement to our products and, as such, we reserve
the right tochange product specifications without prior
notice.
Standard equipment and accessories may vary by
•
country.
Product specifications may differ by country.
•
Complete product range may not be available in all
•
countries.
Contact your local Black & Decker dealers for range
•
availability.
ENGLISH
7
Advertisement
Table of Contents
