Advertisement
Main LCD Screen Menu cont.
• ENABLE MIDI OUT: Each preset can send a MIDI PRESET message to an outboard MIDI enabled piece of
gear using either the MIDI output on the amp or the MIDI output on the Sanpera Pro footcontroller. Enabling
MIDI out allows the user to assign a MIDI preset message for each preset.
• MIDI OUT CHANNEL: If you have several pieces of MIDI gear in your rig, each one can be on a separate
channel so that preset messages do not change all of them at the same time. Either the INNER or OUTER en-
coder will select which channel to use, then pressing the INNER encoder will select that channel.
• RESET PRESET: Resets the selected preset to it's factory settings.
• FACTORY RESET: Press the INNER encoder to get into FACTORY RESET mode, then press and hold the
INNER encoder to return the Vypyr Pro to factory condition.
• DISABLE DEMO: The Vypyr Pro ships to the dealer in DEMO mode. In this mode, when there is no cable
inserted into the input, the amp is in ATTRACT mode, using a light show to attract customers to it. Press the
INNER encoder to disable the demo mode and turn off the light show.
• ENABLE/DISABLE DELAY TRAILS: This feature is where you decide if you want the delay to cut off abruptly
or if you wish for the trails of the delay to be heard within a preset when the delay is turned on or off using the
Sanpera Pro footcontroller. NOTE: Even if the Delay trails are enabled, the user can create another preset with
the delay turned off. In this way, if they wish to abruptly turn off the delay for effect within a song, they could
simply switch to the other preset.
• ENABLE/DISABLE REVERB TRAILS: Same as above only using the reverb.
• SHOW VERSION: Pressing the INNER encoder will display the firmware version. This way, a user can check
www.peavey.com to see if there is a new version of the Vypyr Pro firmware.
• UPDATE SOFTWARE: THIS FEATURE IS NOT YET DEFINED.
• INPUT SENSITIVITY: Because of the varying outputs of different guitars, there is a global Input Sensitivity
feature to allow the user to set this per whatever guitar they might be using. Pressing and releasing the INNER
encoder will go to the screen where the user can define a boost or a cut in the Input Sensititivy. The Vypyr Pro
defaults to 0.00dB. The range is from -9.7dB to +3.0 dB.
• EXIT MENU: Press the INNER encoder to exit the main menu.
Advertisement
