Table of Contents
Advertisement
12.
Set dome section(3) in place; apply the fireplace mortar to the applicable outer edge of
hearth generously.
13.
Apply mortar to the hearth and all sides of the overlapping joint between section (3) & (4).
Interlock the sections tightly together. Refer to illustrations below.
14.
Repeat the above process and attach section(5) to (4).
15.
For the final section(6), apply mortar on the hearth and the joint between section(5) and
(6) as shown below. Set section(6) on rim of hearth and apply mortar to the joint between
section(6) and (3). Slide section(6) into place and adjust the sections as needed to ensure
a tight fit.
16.
Apply mortar in the opening on top of the dome as well as around the sides of the cap. Fit
the cap tightly on the top of oven so that it is flush. Refer to illustrations on the following
page.
17.
Apply mortar to all interior and exterior seams and smooth it out using your finger, trowel
or putty knife. Make sure that all gaps are sealed with mortar.
18.
While the fireplace mortar is drying, attach the chimney following the instructions on page
15.
©Wildwood Ovens and BBQs LLC 2009
12
WWW.WILDWOODOVENS.COM
Installation Instructions
323.255.6587
All specifications subject to change without notice
Toscano
Wood Fired Oven
Version 4.0
Advertisement
Table of Contents
