Turning The Tv On For The First Time - Hisense HL55XT710PZLN3D 710 series User Manual

Turning the TV On for the First Time

1. Connect the mains cable to the mains socket after you have
completed all the connections.
2. Switch on the POWER ON/OFF at the bottom of the TV.
Then the TV switches to on mode.
To mains socket
NOTE
Always disconnect the TV from the mains socket when not
in use for a long period of time.To completely disconnect the
mains power, please remove the mains plug from the mains
socket or switch off the POWER ON/OFF switch.
3. The first time you turn the TV on, it will go straight into the
Setup Wizard -1 menu.
4. Press [▲/▼] buttons to select the language and press [OK]
to confirm.
Then press [►] button to enter the Setup Wizard -2 menu.
Or you can press [EXIT] button to exit the wizard.
5. Press [▲/▼] buttons to select your country and press [OK]
to confirm.
Then press [►] button to enter the Setup Wizard -3 menu.
Or you can press [EXIT] button to exit the wizard.
6. Press [▲/▼] buttons to select the local time zone where
you operate the TV and press [OK] to confirm.
Setup Wizard -3
Please set the local time zone for your TV set:
Back
Then press [►] button to enter the Setup Wizard -4 menu.
Or you can press [EXIT] button to exit the wizard.
7. Press [▲/▼] buttons to select your mode and press [OK]
to confirm.
Basic Features
MENU SOURCE VOL VOL CH CH
NSW/ACT
VIC
QLD
SA
WA
TAS
NT
Select Next Exit
EXIT
8. Press [▲/▼] buttons to select Scan and press [►] button
to enter the next wizard and the TV start to search the
programs automatically
Channel Installation
Back
.
All available TV channels are stored.This display shows the
progress of the tuning and the number of channels found.
You can press [◄] button to return to the last wizard.
If you want to cancel the scan , please press
Channel Installation
Status: Scanning...
ATV Program Installed: 4
DTV Program Installed: 3
9. After scan, the wizard will display congratulations and then
you can press [OK] button to exit the wizard.
Congratulations!!
Completed Initial Setup.
Please press [OK] to exit the wizard.
Back
17
Setup Wizard -5
Scan
Skip Scan
Select Next Exit
EXIT
[EXIT]
Setup Wizard -6
Cancel
EXIT
Setup Wizard -7
Cancel
EXIT
button.