Charge The Battery; Install/Remove The Belt Clip - Uniden Atlantis 290 Owner's Manual

CHARGE THE BATTERY

After installing the rechargeable battery pack,
place your radio in the charger with the display
facing forward. The CHARGE LED on the
charger turns orange. When the battery is
completely charged, the CHARGE LED turns
green.
Charge the battery fully before using the radio. If the radio
is powered down, the battery can charge in about seven
hours. (If the radio is powered on, the battery takes longer to
charge.)
Cautions:
Don't use the charger when the ambient temperature
x
is below 42° F (5° C) or above 104° F (40° C).
Use only the battery and charger supplied with
x
this radio. Using a different charger or battery can
damage the radio and create a risk of fire or shock.
The charger is not waterproof. If the charger falls into
x
the water, unplug it before attempting to remove it
from the water. After you remove the charger from the
water, please contact Customer Service (see the back
cover page for contact information).
Wipe off dirt or shake water from your radio before
x
placing in the charger if your radio gets dirty or wet.

INSTALL/REMOVE THE BELT CLIP

To install the belt clip, slide the belt clip down over the latch
until you hear it click.
To remove the belt clip, lift the flat latch and slide the clip up
until it comes free of the latch.
Uniden Atlantis 290/295 Radio Owner's Manual
E-11