Hardware Setup; Install The Battery - Uniden Atlantis 290 Owner's Manual

Icon
WX
VOL
SQL
88
A
188
:

HARDWARE SETUP

INSTALL THE BATTERY

Your radio comes with a rechargeable Lithium Ion battery; for
shipping safety, the battery is not connected at the factory.
1. Remove the belt clip if installed.
2. Unscrew the battery cover and carefully remove it.
3. Line up the battery's connector with the jack inside the
battery compartment (the connector only fits one way).
4. Push the connector in firmly. Tug on the battery wires
gently to make sure you have a good connection.
5. Before replacing the battery cover, check the rubber seal
located on the under side of the cover; make sure that
the seal is set in the groove and that there is no foreign
matter under the seal.
Note: Each time you remove the cover, check the rubber
seal around the battery compartment. Make sure
the seal is seated in the groove and there is no dirt
or debris on it. If the seal looks worn or damaged,
contact customer service to order a replacement (see
back cover page for contact information)
6. Replace the battery compartment cover. Tighten the
screw securely.
Uniden Atlantis 290/295 Radio Owner's Manual
WX channel selected.
Adjust the Volume level.
Adjust the Squelch level.
Channel number
(Simplex) for Marine band or
A
GMRS/FRS band sub code.
What it means
for
188
E-9