1) on the CD enclosed with this product; 2) on the Web site listed below; or 3) in some cases, printed and enclosed with this product. Contact your INTELLINET NETWORK SOLUTIONS dealer with comments or questions.
softWare installation Driver Installation 1. With the Wireless 802.11n USB Adapter inserted and the computer on, the Found New Hardware Wizard displays a welcome screen. Click “Cancel” to continue with the driver installation. 2. Insert the enclosed driver CD in the CD-ROM drive and run the “Setup.exe”...
Page 5
4. When the second Setup Type screen displays, select “Optimize for WiFi mode” for wireless compatibility, then click “Next.” If you want to enhance your wireless performance, you can select “Optimize for performance mode”; however, wireless compatibility is not guaranteed in this mode. (Refer to the user manual for details of performance mode.) NOTE: If the Found New Hardware screen displays again, ignore it and wait for the next screen.
Page 6
2. The configuration utility will automatically scan for wireless access points, and all those found will be displayed (see above). Select an access point and click “Connect.” NOTE: If the wireless access point you want to connect to doesn’t show here, click “Rescan.”...
Page 7
3. If the wireless access point uses encryption (see above), a WEP password or WPA preshared key needs to be entered. (Obtain whichever is needed from the owner of the wireless access point you want to connect to.) Once the correct entry is made, click “OK.” If the value entered here is wrong, you will not be able to connect to the wireless access point.