Table of Contents
Advertisement
INSTALLATION
Installation
1. Remove the grill from the speaker, if applicable.
2. Connect the speaker wire to the speaker terminals:
• Leave about 2' (60 cm) of wire extending through the ceiling cutout.
• Pull the conductors apart so the last two inches are separated and
remove ½ " (13 mm) of insulation from the end of each conductor.
• Twist the strands in each conductor into tight spirals.
• Attach the speaker wires to the red and black speaker terminals. Connect
the Positive (+) conductor to the Red terminal and the Negative (-)
conductor to the Black terminal. Make sure that no stray strands of wire
are touching the other conductor or terminal.
• Single point speakers have four terminals; Right(+), (-) and Left(+),
(-). Run an extra pair of conductors and observe proper polarity when
making connections.
(+)
Insertion of speaker wire on back of speaker baffl e
8
(-)
Russound Acclaim Thin Bezel Loudspeaker Installation Manual
3. Center the speaker in the cutout. Rotate the frame as needed before
tightening the screws. Tighten the screws equally until the clamps secure
the frame. Do not overtighten.
Cutout
Speaker Cable
Speaker
Screw
Install Speaker
As screws are tightened
clamp will rotate out and
snug against the drywall.
Advertisement
Table of Contents
