Advertisement
Retrofit Installation
Locate existing pipes, duct work, and AC wiring before cutting any holes.
1.
Center the cardboard template between adjacent joists, avoiding all
wiring, pipes, duct work, and lightly mark the outline with a pencil.
Then use a keyhole/drywall saw or motorized spiral-cut tool to make
the opening.
2.
Score the outline of the template with a utility knife to prevent
chipping. If dealing with lath and plaster or thick paneling, drill 1"
(2.5 cm) holes in several places around the pencil outline. Use a
fine-toothed keyhole saw or hacksaw blade with slow strokes to saw
through and remove the inner surface.
Score template outline
Retrofit Installation
3
Russound Architectural Series of In-Wall Loudspeakers
Cut out opening
PREPARATION / SPEAKER PLACEMENT
Additional Tips / Considerations
Try to run speaker wires after AC wiring is in so you can separate the wires,
•
avoiding induced noise caused by close parallel positioning of the two
wire types.
Secure speaker wires in place against a stud along vertical runs. Do not
•
pierce the wire insulation. Allow a bit of slack for expansion of building
materials.
Route horizontal wire runs through holes drilled in studs at roughly equal
•
heights.
Speakers should not be installed until the wallboard is in place. In the
•
meantime, leave several feet of wire coiled up and secured to the back
side of the mounting frame. Excess length can be removed during final
assembly.
When installing the drywall, make sure the speaker cutout hole doesn't
•
extend farther than 1/4" (0.6 cm) from the inside of the mounting frame.
Terminate the wires in an outlet box attached to a stud or retrofit
•
junction box at the exit location. Use an outlet plate with speaker wire
terminations.
After the drywall is secured and finished, install the speakers as we've
•
described.
Painting the Speaker Grille
Russound Architectural Speaker Grilles have a designer white finish that can
be painted with ordinary latex paint. Remove the speaker grille from the
speaker before painting.
1. Remove the magnetic speaker grille and carefully remove the scrim cloth
from the grille and set aside.
2. Paint the grille. Russound recommends diluting the latex paint with water
4:1 or 5:1 proportionally. Due to the fine mesh openings, using several layers of
a thinner paint spray is recommended rather than using a single, thicker coat.
A thick coat is likely to clog the speaker grille openings.
3. While the paint is still wet on the grille, and the grille is not attached to the
frame, use a gentle burst of compressed air against the outside surface to clear
the fine holes in the mesh.
4. After the paint has thoroughly dried, re-attach the scrim cloth.
Speaker
Grille
Scrim Cloth
Speaker Assembly
Do not attach the grille
until the speaker has
been connected and
secured in the wall.
Advertisement
