Related Manuals for Russound ATMOSPHERE
Summary of Contents for Russound ATMOSPHERE
- Page 1 T T h h e e S S o o u u n n d d o o f f t t h h e e A A t t m m o o s s p p h h e e r r e e OWNER’S MANUAL...
-
Page 2: Speaker Wire
ABS plastic baffle and frame). STEREO IMAGING We’re sure you will find that the Atmosphere Series prod- If your Russound Atmosphere speakers are going to be your ucts provide significant and real benefit, utilizing superior... -
Page 3: Other Acoustic Considerations
• Any wall which can’t provide proper depth (clearance) For best fidelity, there are several other factors to keep in for the back of the Russound speaker. This includes brick mind before you start actual installation. or concrete walls where the wallboard or paneling is... -
Page 4: Speaker Preparation
PAINTING THE SPEAKERS If you like the designer white finish which is a part of your Russound Atmosphere speakers, then you are ready to install. But if you want your speakers to completely blend in with a colored wall or accent the surface, now is the time to paint the speakers’... -
Page 5: Speaker Wiring
Try to tighten each screw equally but do not over tighten. 3. Insert the Russound speaker grille by gently pressing it into place. Figure 7... -
Page 6: Listening Test
- try a new cable. 1. Turn on your stereo system. Make sure that the VOLUME 4. Defective speaker - contact your Russound dealer or call control is turned down and that the BALANCE control is Russound Tech Support at 603.659.5170. -
Page 7: New Construction Installation
If you intend to use your Russound Atmosphere speakers at the same time as your main speak- • When it comes time to put up the drywall, make sure ers or if you intend to hook up two pairs of speakers and the speaker cut-out hole doesn’t extend farther than... -
Page 8: Specifications
SPECIFICATIONS Model: SP-A6S Description: Round Single-Point Stereo In-wall/In-ceiling loudspeaker Woofer: 6.5” (16.5 cm) Dual Voice Coil (DVC) with patented structural rib injection molded cone Tweeter: Dual 14mm (0.56”) Neodymium PEI-dome Cut-Out: 8.375” (21.3 cm) Mounting Depth: 3.875” (9.8 cm) Recommended Power: 5 - 60 watts Efficiency: 92 dB (1W @ 1M w/1kHz) Frequency Response: 55Hz - 20kHz +/- 3 dB Nominal Impedance: 8/8 ohms per channel... - Page 9 SPECIFICATIONS Model: SP-A8C Description: Round 2-Way In-wall/In-ceiling loudspeaker pair Woofer: 8” (20.3 cm) with patented structural rib injection molded cone Tweeter: 25mm (1”) Neodymium Mylar-dome Cut-Out: 9.875” (25.1 cm) Mounting Depth: 4” (10.2 cm) Recommended Power: 5 - 120 watts Efficiency: 90 dB (1W @ 1M w/1kHz) Frequency Response: 40Hz - 20kHz +/- 3 dB Nominal Impedance: 8 ohms...
- Page 10 NOTES...
-
Page 11: Warranty
In these cases, repairs will be made on the basis of the retail value of the parts and labor. To return for repairs, the unit must be shipped to Russound at the owner’s expense, along with a note explaining the nature of service required. - Page 12 Russound 5 Forbes Road, Newmarket, NH 03857 tel 603.659.5170 • fax 603.659.5388 e-mail: tech@russound.com www.russound.com...