Magellan NAV 6500 User Manual page 79

3) Fit the threaded adapter onto
the exposed end of the bolt and
screw in the bolt. Make sure to
adjust the direction of the
adapter, by aligning the teeth
as desired, before tightening.
5) Verify that the bolt is level with
or inside the perimeter of the base
plate. (Otherwise, the base will
not rest flat on the surface to
which you are attaching it.)
Magellan NAV 6500/NAV 6510
4) Use a wrench to tighten the
bolt so that it does not protrude
beyond the perimeter of the base
plate.
6) Insert four screws as shown to at-
tach the base plate to the desired sur-
face.
7) Attach the threaded mount on the back of the receiver
using three screws supplied with the unit. (Not shown).
9) Adjust the viewing angle
of the display, then tighten
the bolt through the
threaded mount until the
teeth are interlocking and
the receiver is secured.
8) Fit the threaded mount on
the back of the receiver onto
the threaded bolt adapter you
have just assembled.
71