Error Codes; Troubleshooting - Morphy Richards 562000 Instruction Book

MC562000MEE Rev1.qxp_Morphy Richards Instruction Book 23/03/2015 10:36 Page 24

Error Codes

Error Code
E1
E3
E5

Troubleshooting

Problem
The device doesn't work.•
The buttons (21)-(30) do not react
immediately.
Water is leaking from the Lid (2)
The Lid (2) is open but the Lid Lock Icon (33)
on the Control Panel (8) shows the closed
padlock.
The programme has stopped
before the end.
The Mixing or Pulse functions are not working. The Lid is not correctly attached to the Jug.
24
Cause
The motor is overloaded.
the Jug (4).
Remove any food residue from
the Paddle (11), or Blades (12),(13).
The Jug (4) is not correctly
inserted into the Main Unit (5).
The Jug was removed during use.
The Motor burn out safety switch
has switched on.
Issue
Your Multicooker is not
connected to the mains.
The Mains Lead (19) is not
properly connected to the Cable Socket (7)
on the Main Unit (5).
The On/Off Switch (9) is set to off or your
Multicooker is in standby.
The buttons on the Control Panel (8)
require the right contact time.
The Lid Gasket (16) is not
attached correctly.
There is some food in the
sensor at the top of the Jug
Handle (3) or on the Main Unit (5).
Your Multicooker has lost power
temporarily.
Solution
Reduce the amount of food in
Insert or replace the Jug into the Main Unit.
Let your Multicooker cool down for at least
30 minutes.
If the problem persists after cooling down,
contact Morphy Richards.
Solution
Plug the Mains Lead (19) into the socket on
the wall.
Switch the On/Off Switch (9) to off,
and insert the Mains Lead into
the Cable Socket.
Switch the On/Off Switch on, or
press the Standby Button (22).
Touch or press the buttons for a longer
period.
The Lid Gasket in the Lid is damaged
Check the Lid Gasket on the underneath
of the Lid is in place and correctly attached.
Contact Morphy Richards.
Remove any food residue left on/in
your Multicooker, if the problem persists,
do not use. Contact Morphy Richards.
Switch the On/Off Switch (9) to off,
and check the Mains Lead.
Continue the recipe using the manual settings.
These functions are not available during this
part of the process. Correctly attach the Lid to
the Jug.
Do not try to use.