Operation - Makita 4131 Instruction Manual

1
2
005349
After installing the blade, replace the dust cover. Slide
the dust cover carefully so that the slot of its front fits
the rib of the blade case. Make sure the dust cover fits
properly then push and turn the knob counterclockwise
to the symbol.
1
005350
Rip fence (guide rule) (Accessory)
1
005351
The handy rip fence (guide rule) allows you to do extra-
accurate straight cuts. Simply slide the rip fence up
snugly against the side of the workpiece and secure it in
position with the clamp screw on the front of the base. It
also makes repeated cuts of uniform width possible.

OPERATION

CAUTION:
Never twist or force the tool in the cut. This may
•
cause motor overload
kickback, resulting in serious injury to the operator.
1. Hex socket head
bolt
2. Outer flange
3. Carbide-tipped
saw blade
4. Inner flange
4
3
1. Slot
2. Rib
2
1. Rip fence
(Guide rule)
2 2. Screw
and/or a dangerous
005352
Hold the tool firmly with both hand. Set the base plate
on the workpiece to be cut without the blade making any
contact. Then turn the tool on and wait until the blade
attains full speed. Move the tool forward over the
workpiece surface, keeping it flat and advancing
smoothly until the cutting is completed. Keep your
cutting line straight and your speed of advance uniform.
The sight window in the base makes it easy to check
the distance between the front edge of the saw blade
and the workpiece whenever the blade is set to the
maximum depth of cut.
1
005353
NOTE:
When making a miter cuts etc., sometimes the
•
lower guard does not move easily. At that time,
use the retracting lever to raise the lower guard for
starting cut and as soon as blade enters the
material, release the retracting lever.
1
005354
CAUTION:
Do not use a deformed or cracked blade. Replace
•
it with a new one.
Do not stack materials when cutting them.
•
Do not cut hardened steel, stainless steel,
•
aluminum, wood, plastics, concrete, tile, etc. Cut
only mild steel.
7
1. Carbide-tipped
saw blade
2
2. Workpiece
1
1. Sight window
2. Workpiece
2
1. Retracting lever