Key Functions - Horizon Fitness Titan XP90 Installation And Operation Manual

Hide thumbs Also See for Titan XP90:
Table of Contents

Advertisement

If the unit is handled in such a manner that the compressor did not remain in the upright position,
it is necessary to place on a level surface and wait a minimum of 2 hours before turning the unit "on"
Step #2: Set Up Drain Line
The included drain line attaches to unit via a compression type fitting on the discharge end of the
unit. To attach drain line, remove the compression nut and slide it over the end of the hose to be at-
tached to unit. Slide compression nut side of hose over the insert on the compression fitting com-
pletely. Tighten compression nut.
Step #3: Plug unit into 15 amp grounded circuit.
5.1. Power Key
Use this button to turn the dehumidifier on and off. Press once to turn machine on. You will
hear 2 beeps and the
you will hear one beep as the machine shuts down. Note that there is a one minute fan delay on
shutdown.
6.2. Arrow Buttons
a.
Use the up and down arrow buttons to set the desired humidity setpoint on the display screen.
The setpoint can be any number between 35-99%. Creating a setpoint means that when the
indoor humidity is lower than the set point, the machine will stop automatically. Conversely, when
the indoor humidity is higher than the set level, the unit will operate.
7.3. Continuous Mode
Continuous Mode can be used when you want your dehumidifier to run constantly for testing
purposes, To switch into continuous mode, press either the up or down arrow. Once you hear a
beep, press both arrow buttons simultaneously. At this point the
on the display board to indicate you have successfully switched to continuous mode.
a.
• When set to continuous, the dehumidifier will run constantly, regardless of the humidity level un-
til you turn the unit off or switch back to normal humidistat operation. If you would like to switch
back to normal humidistat operation, simply press the up and down arrows simultaneously.

Key Functions

light will illuminate red. Press the power button a second time
4
light should illuminate green
and

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents