Horizon Fitness Titan XP90 Quick Start Manual

Titan XP90 Quick Start Guide
• To install your new Titan, you will need a 115V, 60Hz, 3-Prong GFI outlet with a 15 amp time
delay fuse or circuit breaker.
• The area where the unit will be installed should be sealed with a vapor barrier. Additionally, if it
is a crawlspace, all vents and openings must be sealed.
• Be sure to route drain line to a suitable drain. The line must flow to drain without any loops or
kinks.

Turning the Unit On/Off

• To turn the dehumidifier on, press the power button
You will hear two beeps as the machine starts to run.
• Once running, the
• To turn the unit off, press the power button
You will hear a single beep as the machine begins the
shut down process. Keep in mind that there is a one
minute fan delay after shut down.

Adjusting the Settings

Humidity Level

• To adjust the humidity level, use the up
display on the screen
• Creating a desired humidity set point means that when the indoor humidity is lower the set
point, the machine will stop automatically. Conversely, when the indoor humidity is higher than
the set level, the unit will operate.

Continuous Mode

• If you need your Titan to run constantly, you can use Continuous Mode. To switch into
Continuous mode, press either the up
beep. Next, press button the up
light should illuminate green on the display board to indicate the unit has been
successfully switched to Continuous Mode.
• Once in continuous mode, the dehumidifier will run constantly regardless of the humidity level
until you turn the unit off or switch back to normal humidistat operation. If you would like to
change to humidistat operation, simply press the up

Compressor Indicator

• The compressor indicator
compressor operation has been initiated and unit is currently warming up. Wait a few minutes
and the compressor will begin to run. Once running, the compressor indicator
green.

Installation

Operation

light will illuminate red.
and down
. The dehumidifier can be set anywhere between 35-95%.
or down
and down
will illuminate red on the display board to show that
again.
arrow button until the desired level is
arrow button until you hear an audible
keys at the same time. At this point, the
and down arrows simultaneously.
will switch to