Model Setting - Pioneer DVR-520H-S Service Manual

1

7.1.2 MODEL SETTING

QQ
• The Setup is Necessary When :
3 7 63 1515 0
a) When the MAIN Assy is replaced
b) When the JCKB Assy is replaced
A
c) When the MAIN Assy and JCKB Assy are replaced
• How to Setup the Model
1) After power on, the following screen is displayed on TV monitor.
Press " 22 " by using the remote control unit for service(GGF1381).
[ Recorder 's Model Setting]
Input the number by using the remote for Service.
> --
Input No.
[ 22 : DVR-520H-S
B
[ 23 : DVR-65H-S
2) After 1), the following screen is displayed on TV monitor.
Press " 011 " by using the remote control unit for service.
[ Recorder 's Type Setting]
Input the number by using the remote for Service.
> ---
Input No.
[ 01 :
C
The setting complete when OSD is disappeared.
TE
L 13942296513
3) Unplug the power cable.
4) Reset the recorder to all its factory settings.
1. Make sure that the recorder is on.
2. Press and hold [STOP] and press [STANDBY/ON] key on the front panel.
The recorder turns off with all settings reset.
5) Enter the Service Mode and then confirm the Model Name " DVR-520H/KU/CA ".
1. Make sure that the recorder is on.
D
2. Press [ESC] then [DISP] keys by using the remote control unit for Service.
DVR-520H/KU/CA
VERSION : 0.60
SYSCON : RELEASE_45
Rev
TUFLCON : 1.22
DRIVE : DVD-RW DVR-107X
1.10K
CKT0000353WL
HDD : ST380012ACE
DEVICE : PRISM-PLUS
REGION : 1
E
: ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗
C
FLASH : 64M
Notes :
1) After the setting complete, you can NOT CLEAR the seting data.
Make sure the pressing number.
2) " NG " is appeared on TV when unsuitable number is pressed.
www
In such a case, please unplug the power cable and plug it again. Then restart the model setting.
F
76
1
http://www.xiaoyu163.com
2
Model
]
]
(Type -- , Region No. -)
Type
KU/CA <US> ]
:1.3685 $
MASK OK
OK
OK
OK
80
x ao
y
. i
2
http://www.xiaoyu163.com
3
Note : Make sure of setting the correct number.
Q Q
3 6 7
u163
DVR-520H-S
3
4
2 9 9 4
8
1 3 1 5 0 5 8 2 9
m
co
.
4
2 8
9 9
9 4 2 8 9 9