Vermont Castings 2040 Installation And Operating Manual page 18

Encore FlexBurn 2040 Non-Catalytic / Catalytic Wood Burning Stove
® ®
Adjust the Leg Levellers
Lift the stove slightly so there is no weight on the leg while
making the adjustment.
Reverse the Flue Collar (If necessary)
Reverse the flue collar by removing the two screws that
attach it to the back of the stove. Be sure the gasket around
the flue collar opening is in position when you screw the
collar back onto the stove.
Attach Flue Collar Heat Shield
WARNING: The flue collar heat shield must be attached
to the Encore stove. Use four #10 sheet metal screws
®
supplied to secure the flue collar heat shield to the rear of
the stove. (Fig. 23)
Sheet
Metal
Screws
Flue Collar
Heat Shield
Fig. 23 Install flue collar heat shield.
WARNING: The flue collar heat shield must be installed
in all vertical installations. The flue collar heat shield is not
used when the flue collar is in the rear exit position.
Attach the Damper Handle
Use the 1/4"-20 x 3" screw to attach the damper handle to
the damper stub on the left side.
Attach the Catalyst Temperature Probe
To install the catalyst temperature probe, remove the
hole plug from the cast iron wall behind the rear shield
as shown (Fig. 24) use two #10 sheetmetal screws and
bracket supplied, secure the bracket and probe to the
back of your stove. Fig. (24)
18
ST1180
Sheet
Metal
Screws
ST1180
flue collar heat shield
Bracket mounting screw
hole location
1.8"
Fold bracket strap
over catalyst probe
1.4"
shaft and secure with
screw.
Insert catalyst probe
through sheet metal
into cast iron back.
Remove hold plug
from cast iron back.
Fig. 24 Install the Catalyst Temperature Probe
Attach the Primary Air Thermostat Handle
The primary air thermostat handle is the smaller of the
two black handles. Secure the handle to the stub on the
right side of the stove with an 8-32 x 2" slot head machine
screw. (Fig. 25)
Fig. 25 Attach the thermostat handle.
Assemble the Removable Insert Handle
ST635
The ceramic removable insert handle opens and closes the
front doors. Remove after each use, and store it in the handle Encore
holder behind the right front leg. Assemble the handle by Install thermostat
passing the 3 ⁄ " screw through the ceramic shaft and into
handle
3
8
the bright metal nub. (Fig. 26) Tighten carefully until snug.
2/01
Fig. 26 Assemble the front door handle.
Insert catalyst
probe bracket with
self-drilling screw.
ST635
ST540
30005295